mmdmmdenL mottoB2〜10mm2〜20mm2〜20mm2〜20mm2〜20mm2〜30mm2〜30mmNON-LITLETTERSIGNSeriesタフライトサイン・Dレター・クリスタルレターiddd××××××××××××××××××××× カット方法の注意点224*Semi-Straight Cut6°Bevel*Semi-Straight Cut8°BevelBevel Angle Notes of TUBE Cutting Artwork Original Logo ArtworkThere are a variety of features such as variable width strokes or calligraphic design. Notes for Bevel Cutting Style15°Bevel45°BevelFeatures of Converted Logo ArtworkBevel Angle and Offset Distance ComparisonCreating PathsNot just tracing the center lines but we keep the original logo features when creating the special artwork. Provided Artwork*Please note that your provided logo artwork will be converted into a special artwork for production.Actual Letter*This is a Separated Layout.15°20°30°End of line becomes round.Section45°60°*This is a Good Connected Layout. The joint is strong enough.There are many selectons of bit heads, each suitable for any design. We can provide custom angles, please contact us for details.Logo’s stroke width becomes even.The outline of the provided artwork becomes the surface line of the actual letter. The bottom line is offset "d-mm" from the outline edge. Each letter can be connected or separated depending on the layout and the angle of the bit head. We usually recommend that you choose the connected layout, since it is much easier to install. It is important to note that if the connections are too small, the joints may break. However, if you follow the specs in the table below, we can ensure a successful install. For separated letters, the gap between the letters needs to be at least twice the gap as with the connected letters.20°Bevel30°Bevel60°BevelAngle of Bit HeadThicknessWide JointAngle6° (Semi-Straight Cut)OffsetThicknessABS2mm0.21mm3mm0.31mm5mm0.53mm8mm0.84mm10mm1.05mm15mm1.58mm20mm2.1mm25mm2.63mm30mm3.15mm1: For Connected Layout, keep the distance small, as indicated in the table.2: For Separated Layout, make the gap twice the measurement indicated in the table.*This is a Poor Connected Layout. The joint is not strong enough.Round inner corner becomes sharp.Narrow Joint8° (Semi-Straight Cut)OffsetOffsetAcrylicABS, AcrylicABS, Acrylic0.28mm0.54mm0.42mm0.7mm1.34mm1.12mm2.14mm1.4mm2.68mm2.1mm4.02mm2.81mm5.36mm3.51mm4.22mmDecide the Stroke WidthWe will propose the most suitable stroke width based on the signage size and generate the special artwork for production. Once you approve it, we will start the production.dmmBottom LineOffsetOffsetABS, AcrylicABS, Acrylic0.73mm1.15mm0.8mm1.09mm1.73mm1.82mm2.89mm2.91mm4.62mm3.64mm5.77mm5.46mm8.66mm7.28mm11.54mmThicknessSurface LineNeeds gap morethan d × 2OffsetOffsetABS, AcrylicABS, Acrylic2.0mm3.46mm3.0mm5.19mm5.0mm8.65mm8.0mm13.84mm10mm17.3mm15mm20mmScan the QR code for Website.英語版カタログはQRコードを読み取ってください。NON-LIT LETTER SIGN Seriesタフライトサイン・Dレター・クリスタルレター カット方法の注意点
元のページ ../index.html#224