to i ･ Dレター ･ Hownstallタフライトサインクリスタルレター取付方法 Match the marked point and the vertical center line of the template, and fix the plastic template to the wall.Please install the letters immediately after peeling off the backing. The letters must be installed at room temperature. A commercial dryer can be used to heat the surface if the surface temperature is below room temperature.After installation of all the letters, take a clean cotton cloth and apply about 30kg of pressure equally to each letter for 5-10 seconds. Letter adhesion may fail if pressure is not applied.We recommend that you lay out the letters to become familiar with them before installing the letters onto the wall. We also recommend that you start with larger letters.Repeat steps 05 and 06 until all letters are installed.Remove the plastic template carefully not to pull on the letter edges.267*The letters are made of resin. If they are too hot they may change shape and lose quality.*Use glue for small letters for secure installation.*The double–sided adhesive tape is very strong on its first application. But, detachment and re-installation may weaken the adhesion, and possibly cause it not to stick properly. Please be careful.040608050709
元のページ ../index.html#267